GAI-Tronics 12511-001 Dynamic Transmitter (NC) w/Cap - Manual

Pub. 42003-028D
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 „ 800-492-1212 „ Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
Dynamic Noise-Canceling Transmitter with
Cap Replacement Kit
M
ODEL
12511-001
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains sensitive
business and technical information that is confidential and proprietary to GAI-Tronics. GAI-Tronics
retains all intellectual property and other rights in or to the information contained herein, and such
information may only be used in connection with the operation of your GAI-Tronics product or system.
This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any third party.
General Information
This kit services the following models:
• 260-14
• 270-14 • 701-201 • 701-202
• 701-203 • 701-204 • 701-205 • 9001
• 9005 • 9081 • 9085 • 9101A
• 9105A • 9201A • 9205A
This kit includes the following components:
Qty Description
1 Transmitter
1 Plastic
Washer
1 Transmitter Cap
Installation
1. Remove the old transmitter cap from the handset by twisting it counterclockwise.
2. Remove the plastic ring from the transmitter, and discard it.
3. Lift out transmitter and disconnect the 2 wires connected to it. Discard the old transmitter and cap.
4. Using a small, standard screwdriver, reconnect the wires to the new transmitter. The order of the wires
does not matter. Once the wires are connected, place the transmitter back into the handset.
5. The transmitter must hook behind the strain relief bushing to secure the cord.
6. Lay the plastic ring over the transmitter.
7. Place the new transmitter cap over the plastic ring and transmitter, and tighten it by twisting it
clockwise.