GAI-Tronics ICS Page/Part Handset/Speaker Amplifier Station - Manual (Page 2)

Pub. 42004-717L2GQG
ICS Page/Party
®
Station Quick Installation Guide Page 2 of 2
e:\standard ioms - current release\42004-xxxxqg quick guides\42004-717l2gqg.doc
03/15
Available Adjustments
Most optional equipment is preconfigured to a default standard at the factory. The
following is a partial list of the available adjustments and settings that may be needed:
Main PCBA VLC Option SmartSeries Option

Speaker Volume

Speaker Volume

FSK Transmit Level

Receiver Volume

VLC Override

Address
 Transmit Level  Test Tone
 Mutual Muting  Page Control Termination PCBA
 Remote Signaling  Speaker Impedance
Figure 3. Typical installation wiring configuration
N OTE : Station input power can be through system cable or through a separate power source cable.
See Pub. 42004-717L2 for the possible beacon, RTU activation, and speaker impedance configurations.
Front Cover Reattachment
Connect any cable harnesses that were disconnected during mounting. Place the front cover on the rear enclosure, being careful not to
pinch any cables. Attach the front cover with the four screws and washers provided. Torque the screws to 10–12 in-lbs (1.13–1.36 n-
m).
NRTL Listed for USA and Canada ....................................................................................................................... UL/CSA 60950
CE Mark
NEMA 12
Figure 2. Suggested wire
entry locations