GAI-Tronics 69439-001 External Audio Interface (EAI) - Manual (Page 7)

Pub. 42004-677L2C
Model 69439-001 External Audio Interface Page: 7 of 9
f:\standard ioms - current release\42004 instr. manuals\42004-677l2c.doc
11/10
Installation and Maintenance
Direct questions about installation of this product to the GAI-Tronics Field Service Department at
800-492-1212 inside the USA or 610-777-1374 outside the USA.
Installation Guidelines
WARNING
Disconnect power to the card rack before performing any maintenance.
Installation Instructions
1. Remove the EAI from its protective carton.
2. Verify that power is disconnected to the card rack prior to installation.
3. Verify that the five board switch and jumper settings described in the Switch and Jumper Settings
section on page 5 are set in accordance with the instructions in your system manual.
4. Align the EAI into the upper and lower tracks for the card rack slot.
5. Slide the EAI toward the rear of the card rack until it comes in contact with the connector on the
backplane.
6. Firmly press on the front bezel until the EAI is seated in the backplane connector, and tighten the two
screws located on the front bezel to secure it to the card rack.
Removing the EAI Card from Card Rack
1. Remove power from the card rack.
2. Remove the two screws on the front bezel that secures the EAI to the card rack.
3. Gently disengage the EAI from the connector on the backplane and slide the EAI out of the card rack.