GAI-Tronics 703-005 Indoor RTU Enclosure User Manual
Page 2
Pub. 42004-617L2D
Model 703-005 SmartSeries
®
Indoor RTU Enclosure
Page
2 of 12
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-617l2d.doc
10/03
Application
The SmartSeries
®
Station RTU is designed to be used with the SmartSeries
®
amplifiers and handsets in a
standard multi-party Page/Party
®
system. It is also possible to control an external device by activating and
deactivating a single relay circuit located in the SmartSeries
®
station enclosure. This circuit is referred to
as a relay output. Terminal block TB3, located on the rear panel of the station enclosure, provides an
interface with this relay.
In addition to the relay output capability, the RTU also provides two inputs. These circuits provide an
interface to dry contact switches, (e.g., a pull box) that are monitored within the SmartSeries
®
station. The
SmartSeries
®
station reports any switch activation to the Master Control Unit (MCU).
The relay output is factory-set to be supervised through input #1. Refer to Figure 1. However, you may
elect to use input 1 by disconnecting supervision for the relay output.
Figure 1.