GAI-Tronics 295-702F, 295-702W VoIP Clean Telephones - Manual (Page 17)

P UB . 42004-470E
V O IP C LEAN P HONE
®
T ELEPHONES P AGE 17 of 22
e:\standard ioms - current release\42004 instr. manuals\42004-470e.doc
02/15
Recommended Cabling
Table 5. Recommended Cabling
Cable Use Size and Type
LAN Cat5 or Cat5e cable with an RJ45 connector
Power Two-conductor, No. 22 AWG is typical
Inputs Two-conductor, No. 22 AWG is typical
Output contacts Two-conductor, No. 18 AWG is typical
VoIP Telephone Input Contacts
Each VoIP Clean Phone ® Telephone accepts four volt-free inputs. Refer to the “Specifications” section
of this manual for the input ratings.
The function of each input is configurable. Inputs can be configured for one of the following modes: On,
Off, or On/Off. The signals can also be inverted between active high (INVERT) or active low
(NORMAL). Activation of these inputs can be configured to update a SYSLOG or generate an email.
Please refer to Figure 9 on page 15 of this manual and the “Logic Settings” section of GTC Pub. 42004-
396, “VoIP Telephone Configuration Guide” for programming instructions for these inputs.
VoIP Telephone Output Contacts
Each VoIP Clean Phone ® Telephone contains two voltage-free output contacts. Refer to the
“Specifications” section of this manual for the output ratings. Both outputs are single-pole, single-throw
contacts.
The function of each output is configurable. Outputs can be configured for one of the following modes:
On, Off, Pulse, Mute, Ring, Call, Connect, Hook, In Use, Ring Cadence, Ring Out, Page, Registered, or
Emergency. In some modes, the duration of the activation or on/off times can also be set. Please refer to
Figure 9 on page 15 of this manual and the “Logic Settings” section of GTC Pub. 42004-396, “VoIP
Telephone Configuration Guide” for programming instructions for these outputs.
Status Indication
Power
The Power LED located on the VoIP PCBA illuminates when power is applied to the telephone. Please
refer to Figure 9 on page 15 for location.
Heartbeat
The Heartbeat LED located on the VoIP PCBA will flash when the telephone is operational over the
LAN. Please refer to Figure 9 on page 15 for location.
EACT
The EACT LED located on the VoIP PCBA will turn ON when VoIP PCBA is connected to an Ethernet
device and flash when data is being transmitted. Please refer to Figure 9 on page 15 for location.