GAI-Tronics ICS Page/Party Desk-edge Subset - Manual

Pub. 42004-428BQG
GAI-Tronics Corporation 400 E. Wyomissing Ave. Mohnton, PA 19540 USA
610-777-1374  800-492-1212  Fax: 610-796-5954
V ISIT WWW . GAI - TRONICS . COM FOR PRODUCT LITERATURE AND MANUALS
G A I - T R O N I C S ® C O R P O R A T I O N
A H U B B E L L C O M P A N Y
ICS Page/Party ® Desk-Edge Subset Quick Installation Guide
Important Safety Instructions
1. Read, follow, and retain instructions – All safety and operating instructions should be read and followed before operating the unit.
Retain instructions for future reference.
2. Heed warnings – Adhere to all warnings on the unit and in the operating instructions.
3. Attachments – Attachments not recommended by the product manufacturer should not be used, as they may cause hazards.
4. Servicing – Do not attempt to service this unit by yourself. Opening or removing covers may expose you to dangerous voltage or
other hazards. Refer all servicing to qualified service personnel.
5. DB25 connection – The supplied DB25 interconnect cable is designed to be plugged into an ICS Page/Party ® remote amplifier
only.
General Information and Available Options
This guide covers the installation of the ICS Page/Party ® Desk-Edge Subset, which is
designed to be installed indoors where space is limited with a remote amplifier. It
features one-way page announcements over system speakers, full-duplex party line
communication, and a durable, highly visible orange powder coat finish. Figure 1 shows
the multi-party desk-edge subset. The desk-edge subset is available with the following
options:

Single or multi-party system option

PVC or Hytrel ® handset cords in 6-, 15-, or 25-foot lengths

Conformal coating for PCBA
Refer to Pub. 42004-428 at the “Manuals & Specs” link at www.gai-tronics.com for
detailed explanations of the available options, system information, and warranty.
Mounting and Connection
WARNING Do not install this equipment in hazardous areas. Such
installations may cause a safety hazard and consequent injury or property damage.
1. Refer to Figure 2 for the desk-edge mounting bracket hole locations and sizes.
2. Secure the bracket to a vertical surface using two #8 screws in the 0.20-inch
(5.1mm) holes on the side of the mounting bracket. Refer to Figure 3 for a typical
installation.
3. Attach the subset to the mounting bracket with the two #10-32 screws and washers
provided. To do this, align the two threaded holes on the bottom of the subset with
the through-holes on the mounting bracket.
4. Plug the interconnect cable into the subset and the remote amplifier. Secure the
interconnect cable thumbscrews to assure the plug does not disconnect. Figure 1. ICS Multi-Party Desk-Edge Subset
Front View