GAI-Tronics 234SBM Stanchion Broadcast Module - Manual (Page 5)

Pub. 42004-416A
Model 234SBM Stanchion Broadcast Module Page: 5 of 5
f:\standard ioms - current release\42004 instr. manuals\42004-416a.doc
10/08
Model 12234-100 Dual-Band Antenna Kit
Refer to Pub. 42003-220 for installation of the antenna kit (when applicable.)
Model 12538-201 Speaker Kit & 12539-201 Vacancy Kit Installation
Refer to Pub. 42003-221 for installation of speaker and vacancy kits.
Model 40201-010 Battery Installation
1. Batteries are shipped separately and are to be installed on site. Pay strict attention to battery polarity,
as reverse power will cause damage to internal components.
2. Make the wiring connection to the electronics module labeled 12V BATTERY (red+, black-) with
battery cable. It is recommended that this be left disconnected from the module until you are ready to
power up the unit.
3. Attach the fast-on connectors to the batteries observing polarity (red+, black-) per drawing 73520.
4. Secure the batteries into L-bracket inside stanchion under phone opening.
N OTE : If the stanchion body does not have any L-brackets, the battery must be set in the bottom of
the stanchion to the side, away from the conduit entries.
Refer to Pub. 42004-415, Model 10458-10x Electronics Paging Module Manual for interconnections and
installation.
Maintenance
Repairing Surface Damage to Powder-Coated Stanchions
1. Carefully sand the damaged area to clean and score the base metal, taking care to minimize any
additional damage to the surrounding powder coating.
2. Wipe the sanded area with a cleaning solvent, such as DuPont “PrepSol.” Allow the area to dry. This
type of product is available at auto parts stores. Denatured alcohol may also be used.
3. Prepare the bare metal surface for painting by treating it with phosphoric acid solution intended for
this purpose. Allow the area to dry.
4. Using a cotton swap or small brush, paint the prepared surface with an automotive enamel or oil base
polyurethane enamel such as Red Devil or Rustoleum. DO NOT USE Krylon-type paints. Carefully
blend the repair enamel into the powder coat at the edges.
N OTE : EXACT color matches may not be attainable.
Specifications
Dimensions ................................................................. 10 W
× 10 D × 18 H inches (0.25 × 0.25 × 0.46 m)
Wall thickness ..................................................................................................... 3/16-inch hot rolled steel
Finish .............................................................................................................................. Powdered coated