GAI-Tronics 226-003 S.M.A.R.T. Phones with Keypads User Manual
Page 13

Pub. 42004-349F
S.M.A.R.T.
P
HONES WITH
K
EYPADS
P
AGE
12 of 21
f:\standard ioms - current release\42004 instr. manuals\42004-349f.doc
04/09
Surface Mount Applications
N
OTE
: The back box is not required for use with the Model 236 Series Surface Mount Enclosure and
should be removed.
1. Drill or punch conduit entries.
WARNING
To prevent accidentally damaging equipment, drill all holes before
mounting the telephone.
2. Use silicone sealant or equivalent around the telephone gasket and the mounting surface for an
effective perimeter seal. This is particularly important if the mounting surface is uneven.
3. Install the telephone line suppressor (customer-supplied) on the telephone line, if applicable.
4. Attach the telephone’s front panel to the mounting flanges of the Model 236 Surface Mount
Enclosure using the six #10-32 tamper-resistant screws and washers provided.
5. Connect the USOC RJ11C (USA) or CA11A (Canada) modular connector of the supplied telephone
cord to the incoming subscriber line, or (if applicable) the telephone line suppressor using the
appropriate mating connector. Check the telephone by calling to and from another phone.
Figure 11. Model 276-003 Mounting Details