GAI-Tronics H96032D 12 V DC @ 4.2 A Rack-Mount Power Supply - Manual (Page 2)

Pub. 42004-281
Model H96032D 12 V dc @ 4.2 A Rack-Mount Power Supply Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-281.doc
3/98
Figure 2. Power Supply Rear Terminations
Installation
WARNING
Disconnect ac power during wiring. This device can present a shock hazard. Please use care when
handling this device and be sure that the ac power is not connected during wiring.
Wiring
Depth clearance behind the mounting rails should be at least eight to ten inches for wiring.
1. Run the power cord to the ac power receptacle, and connect the cord to the 120 V ac power receptacle
as shown in Figure 2.
2. Run the dc power conductors from the devices requiring 12 V dc power, to the output terminals as
shown in Figure 2.
Specifications
Input power .......................................... Nominal: 120 or240 V ac; Range: 85-264, 50/60Hz, single phase
Output power.................................................................................................... 12 V dc @ 4.2A maximum
Output type ...............................................................................................................Switched @ 120 kHz
Output overload protection....................................................................................Output switches @ 5 Hz
Efficiency ....................................................................................................76% typical @ maximum load
Controls................................................................................................ On/off toggle switch on front panel
Indicators ................................................................. Red LED on front panel (illuminates when operating)
Material/Finish ..............................................16 gauge cold rolled steel with gray polyurethane paint finish
Mounting......................................................................Standard 2U (3.5 inch) 19-inch EIA rack mounting
Connections .....................................................................................................Barrier type terminal blocks
Dimensions...................................................................3.5 (88) H
× 19 (483) W × 6 (152) D; inches (mm)
Temperature range................................................................................0º C to +49º C (+32º F to +120º F)
Humidity ......................................................................................................... 0% to 85% non-condensing
Weight......................................................................................................... Approximately 3 lbs (1.36 kg)