GAI-Tronics 232-001 Pole Mounting Kit - Manual (Page 2)

Pub. 42004-105
Model 232-001 Pole Mounting Kit Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-105.doc
2/97
Pull the band around the pole, back through the center slot in the bracket, and through the clamp as shown
on Figure 2.
To Tighten
Pull the band tight, and maintain the tension while tightening the bolt. See
Figure 3.
To Remove
Loosen the bolt to the fully retracted position. Press down on the bolt, and
feed the loose end of the strap back through the slot. See Figure 5.
Enclosure Mounting
1. Loosen the four captive screws, and swing the front door open to the
left. Disconnect any cables or connectors, and pull the front assembly
unit away from the rear enclosure.
2. Mount the rear enclosure to the bracket using the 3/8
-
inch shoulder
bolts and Teflon seal washers. See Figure 5.
3. Replace the front assembly, and reconnect all cables. Tighten the four
outer screws.
Figure 5.