GAI-Tronics 231-001 Pole Mounting Kit - Manual (Page 2)

Pub. 42004-099A
Model 231-001 Pole Mounting Kit Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-099a.doc
7/97
Put the band around the pole and back through the center slot in
the bracket, then through the clamp. See Figure 2.
Tightening the Band
Pull the band tight, and maintain the tension while tightening the
bolt. See Figure 3.
Removing the Band
Loosen the bolt to the fully retracted position. Press down on the
bolt, and feed the loose end of the strap back through the slots.
See Figure 4.
Mounting the Enclosure
N OTE : The following steps should be completed only after the
bracket has been mounted to the pole.
1. Loosen the four captive screws, and swing the front door open
to the left. Disconnect any cables or connectors, and pull the
front assembly unit away from the rear enclosure. If the unit
is equipped with hinges, remove them by pulling them out of
the rear enclosure holes.
2. Mount the rear enclosure to the bracket using the Phillips
Fillister head 1/4-20 by ½-inch machine screws. Refer to
Figure 5.
3. Replace the front assembly, and reconnect all the cables.
Tighten the four outer screws.
Figure 2. Installing the Band
Figure 3. Tightening the Band
Figure 4. Removing the Band
Figure 5. Mounting the Enclosure