GAI-Tronics 230-001 Pole-Mounting Kit - Manual (Page 2)

Pub. 42004-091A
Model 230-001 Pole Mounting Kit Page: 2 of 2
\\s_eng\gtcproddocs\standard ioms - current release\42004 instr. manuals\42004-091a.doc
6/00
To Install: With the screw fully retracted, wrap the band around the
pole. Insert the free end of the band through the bottom slot in the
bracket. See Figure 2.
To Tighten:
Pull the band tight around the pole, and maintain the
tension while pulling the band back away from the screw. Tighten
the thumbscrew. For extra clamping pressure, use pliers or a wrench.
See Figure 3.
To Remove: Loosen the thumbscrew to the fully retracted position.
Press down on the thumbscrew, and feed the loose end of the strap
back through the slot. See Figure 4.
Lexan ® Enclosure Mounting
Use the hex head 5/16-18
× 1-inch machine screws, lock washers,
and flat washers, to bolt the enclosure onto the bracket as shown in
Figure 5.
Polyester Enclosure Mounting
1. Open the door to gain access to the equipment.
2. Loosen the four outer screws, pull back the mid-section, disconnect any cables, and pull the unit away
from the rear enclosure.
3. Mount the rear enclosure to the bracket using the Phillips head ¼-20
× 1-inch machine screws and lock
washers. See Figure 6.
4. Replace the mid-section by reconnecting the cables, pushing the mid-section into place, and tightening
the four outer screws.