Chapter 2 installation instructions, S-ata connectors: sata_1, sata_2(optional) – Foxconn 661FX7MI-RS User Manual
Page 23
Chapter 2 Installation Instructions
16
USB Headers: F_USB1, F_USB2
Besides four USB ports on the rear panel, the
series of motherboards also have two 10-pin
header on board which may connect to front
panel USB cable (optional) to provide addi-
tional four USB ports.
F_USB1/2
VCC
D+
D-
Empty
GND
NC
D+
D-
GND
VCC
Fan Connectors: CPU_FAN, SYS_FAN
The speed of CPU_FAN and FAN1 can be de-
tected and viewed in “PC Health Status” sec-
tion of the CMOS Setup. These fans will be au-
tomatically turned off after the system enters
suspend mode.
CPU_FAN
POWER
GROUND
CONTROL
S ENS E
1
SYS_FAN
SENSE
+12V
GND
1
Audio Connectors: CD_IN,AUX_IN(optional)
CD_IN ,AUX_IN are Sony standard CD audio connector, it can be connected to
a CD-ROM drive through a CD audio cable.
CD_IN
CD_L
GND
CD_R
1
AUX_IN
AUX_L
GND
AUX_R
1
The Serial ATA connectors are used to connect
the S-ATA devices to the motherboard. These
connectors support the thin Serial ATA cables
for primary internal storage devices. The cur-
rent Serial ATA interface allows up to 150MB/s
data transfer rate.
S-ATA Connectors: SATA_1, SATA_2(optional)
SATA_1,SATA_2
GND
GND
GND
TX+
TX-
RX+
RX-
1
PDF 文件使用 "pdfFactory" 试用版本创建