Foxconn 6497MC-RSH - Manual (Page 42)

Chapter 3 BIOS Description
36
PDF 文件使用 "pdfFactory" 试用版本创建 www.fineprint.com.cn
v Onboard FDC Controller
This option is used to set whether the Onboard FDC Controller is enabled.
The available setting values are: Disabled and Enabled.
v Onboard Serial Port 1/2
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard serial port 1/2.
Note: Do not try to set the same values for serial ports 1 and 2.
v UART Mode Select
Use this option to select the UART mode. Setting values include Normal,
IrDA, ASKIR. The setting value is determined by the infrared module installed
on the board.
v UR2 Duplex Mode
This option is available when UART 2 mode is set to either ASKIR or IrDA. This
item enables you to determine the infrared function of the onboard infrared chip.
v Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O address
and interrupt request (IRQ).
v Parallel Port Mode
Select an address and corresponding interrupt for the onboard parallel port.
v ECP Mode Use DMA
Select a DMA Channel for the parallel port when using the ECP mode. This
field is only configurable if Parallel Port Mode is set to ECP.
Onboard SuperIO Device Menu