Foxconn 6497MC-RSH User Manual
Page 19
Chapter 2 Installation Instructions
13
Front Panel Connector: FP1
This motherboard includes one connector for connect-
ing the front panel switch and LED indicators.
HDD LED Connector (HDD_LED)
The connector connects to the case’s
HDD indicator LED indicating the activity
status of hard disks.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PWRLED)
Attach the connector to the power LED on the front panel of the case. The Power
LED indicates the system’s status. When the system is in S0 status, the LED is
on. When the system is in S1 status, the LED is blink; When the system is in S3,
S4, S5 status, the LED is off.
Power Switch Connector (PWRSW)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
FP1
1
Fan Connectors: CPU_FAN, SYS_FAN1, SYS_FAN2
The fan speed of CPU_FAN, SYS_FAN1 and SYS_FAN2 can be detected and
viewed in “PC Health Status” section of the CMOS Setup. Plug the CPU cooling
fan cable into the
4-pin CPU FAN power supply on the motherboard. Connect
the case or system cooling fan connector to SYS_FAN1 or SYS_FAN2.
SYS_FAN1/2
+12V
GND
SENSE
1
CPU_FAN
+
-
+
-
HDD_LED
NC
R E S E T
PW RLED
PW R SW
Empty
SENSE
POWER
GND
1
CONTROL
PDF 文件使用 "pdfFactory" 试用版本创建