Foxconn Q9657MC-8KRS2H V1.1 - Manual (Page 41)

Chapter 3 BIOS Description
35
Load Defaults Setting
Press to select this option. A dialogue box will pop up that allows you to
load the default BIOS settings. Select and then press to load the
defaults. Select and press to exit without loading. The defaults set by
BIOS set the basic system functions in order to ensure system stability. But if
your computer cannot POST properly, you should load the fail-safe defaults to
restore the original settings. Then carry out failure testing. If you only want to
load the defaults for a single option, you can select the desired option and
press the key.
Set Supervisor/User Password
The access rights and permissions associated with the Supervisor password are
higher than those of a regular User password. The Supervisor password can be
used to start the system or modify the CMOS settings. The User password can
also start the system. While the User password can be used to view the current
CMOS settings, these settings cannot be modified using the User password.
When you select the Set Supervisor/User Password option, the following message
will appear in the center of the screen, which will help you to set the password:
Enter Password:
Enter your password, not exceeding 8 characters, then press . The
password you enter will replace any previous password. When prompted, key in
the new password and press .
If you do not want to set a password, just press when prompted to enter
a password, and in the screen the following message will appear. If no password
is keyed in, any user can enter the system and view/modify the CMOS settings.
Password Disabled!!!
Press any key to continue …
Load Fail-Safe Defaults
Select this option to press , it will pop out a dialogue box to allow you to
load default set by BIOS. Select and then press Enter to load default. Select
and press , it will not load. The defaults set by BIOS have set the
basic functions of system in order to ensure the stability of system. But if your
computer fails to properly run, you may load the default to make the system
recover normal, then carry out failure testing in next step. If you only want to load
the default in an option, you can select this option and press the key .
PDF 文件使用 "pdfFactory" 试用版本创建 Æ Æ www.fineprint.com.cn