Foxconn FlamingBlade User Manual
Page 52
45
3
Memory Settings
► IMC Configuration
This item is used to enable or disable memory parameter settings.
► Channel Configuration
Options are: Independent, Mirror, Lock, Spare.
► Channel Interleaving
This item is used to set Max. DRAM channel interleave. Options are: from 1 way to 6 way.
► Rank Interleaving
Interleaving allows banks of SDRAM to alternate their refresh and access cycles. One
bank will undergo its refresh cycle while another is being accessed. This improves memory
performance by masking the refresh cycles of each memory bank.
However, bank interleaving only works if the addresses requested consecutively are not in the
same bank. Option are: 1 way, 2 way and 4 way.
► Virtual XMP
Intel XMP is a performance-packed expansion of the standard DDR3 memory specification,
enabling a robust, overclocking solution designed to take advantage of the mega-gaming
features built into Intel® technology-based PCs. If you like to overclock and squeeze every
possible ounce of performance from your PC, then memory based on Intel XMP is the solution
you need to destroy your enemies and save the universe without breaking a sweat.
This item is used to enable or disable Intel XMP.
► tCL (CAS Latency)
This item controls the CAS latency, which determines the timing delay (in clock cycles) before
SDRAM starts a read command after receiving it.
► tRCD (RAS to CAS Delay)
This item allows you to select a delay time (in clock cycles) between the CAS and RAS strobe
signals.
► tRP (RAS Precharge)
This item allows you to select the DRAM RAS precharge time (in clock cycles).
► tRAS (Precharge Delay)
This item allows you to set the precharge delay time (in clock cycles).
Phoenix - AwardBIOS CMOS Setup Utility
Memory Settings
******** Memory Controller Settings ********
Item Help
IMC Configuration
Enabled
Channel Configuration
Independent
Menu Level ►
Channel Interleaving
6 way
Rank Interleaving
4 way
************** Memory Timings **************
Virtual XMP
Disabled
x DRAM Timing Control
By SPD
x tCL (CAS Latency)
Auto
x tRCD (RAS to CAS Delay)
Auto
x tRP (RAS Precharge)
Auto
x tRAS (Precharge Delay)
Auto
x CR (Command Rate)
Auto
x tRFC (Refresh Cycle Time)
Auto
x tWR (Write Recovery Time)
Auto
x tWTR (Write to Read Delay)
Auto
x tRRD (RAS to RAS Delay)
Auto
x tRTP (Read to Precharge)
Auto
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
Enabled