Foxconn FlamingBlade - Manual (Page 110)

103
5
5-4 Install a New Windows XP
1. Press to enter BIOS Setup during POST.
2. Insert the Windows installation CD into the optical drive.
3. Set the “1st Boot Device” to “CDROM”, save changes and exit the BIOS setup.
4. The computer will reboot, and it will start installing Windows Operating System.
Watch the screen carefully, when the following picture appears, press key
immediately. If you forgot to do this, PC will go to an fatal blue screen, and you
may need to reboot the system again. PC may not respond to your input
immediately, and it keeps loading files until the next screen displays.
Windows Setup
Press F6 if you need to install a 3rd party SCSI or RAID driver.
W
hen you set the SATA Mode in BIOS to either AHCI or RAID, you need
to follow these steps to install your Windows XP system.
C
AU
TI
O
N
!
Phoenix - AwardBIOS CMOS Setup Utility
Boot Setting Configuration
► HDD Boot Priority Press Enter Item Help
► Removable Boot Priority Press Enter
1st Boot Device CDROM Menu Level ►
2nd Boot Device Hard Disk
3rd Boot Device Removable Select Hard Disk Boot
Boot Other Devices Enabled Device Priority
Boot Up NumLock Status On
Gate A20 Option Fast
Security Option Setup
APIC Mode Enabled
MPS Version Control For OS 1.4
OS Select For DRAM > 64MB Non-OS2
Report No FDD For WIN 95 No
HDD Detection Delay (s) 0
Display Full Screen Logo Enabled
Display Quantum Logo Enabled
Display Summary Screen Disabled
Debug Code Control LPC
System BIOS Cacheable Enabled
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
CDROM