Foxconn 720A - Manual (Page 44)

3
37
USB Devices
► USB 1.1 Controller
This item is used to enable or disable the Universal Host Controller Interface for USB.
► USB 2.0 Controller
This item is used to enable or disable the Enhanced Host Controller Interface for USB.
► USB Operation Mode
This item is used to set the USB operation mode. If you select the [High Speed], then the USB
operation mode is determined by the USB device; select [Full/Low Speed], the USB device
operates on full/low speed.
► USB Keyboard Support
This item is used to enable the support for USB keyboard on legacy OS. If you have a USB
keyboard, set to enabled.
► USB Mouse Support
This item is used to enable the support for USB mouse on legacy OS. If you have a USB
mouse, set to enabled.
► USB Storage Support
This option is used to set whether the USB Mass Storage controller is enabled in a legacy
operating system (such as DOS).
► ***USB Mass Storage Device Boot Setting***
BIOS auto detects the presence of USB Mass Storage Devices, you can configure the boot
setting mode for the detected USB device. Setting Options: [Auto]; [FDD Mode]; [HDD Mode].
Phoenix - AwardBIOS CMOS Setup Utility
USB Devices
USB 1.1 Controller [ ] Item Help
USB 2.0 Controller [Enabled]
USB Operation Mode [High Speed] Menu Level ►
USB Keyboard Support [Enabled]
USB Mouse Support [Enabled] [Enable] or [Disable]
USB Storage Support [Enabled] universal host
controller interface
*** USB Mass Storage Device Boot Setting *** for universal serial bus
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Enabled