Foxconn 720A - Manual (Page 43)

3
36
SuperIO Devices
► OnBoard FDC Controller
This item is used to enable or disable the onboard FDC controller.
► OnBoard Serial Port 1
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port COM1.
► OnBoard Serial Port 2
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port COM2.
► Serial Port 2 Mode Select
This item is used to configure COM2 PORT as :
[Normal] : A RS232 device.
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASKIR] : A faster IrDA for 1152000 bit/s.
► IrDA Duplex Mode
This item enables you to determine the transfer mode of the onboard infrared chip.
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Devices
OnBoard FDC Controller [Enabled] Item Help
OnBoard Serial Port 1 [3F8/IRQ4]
OnBoard Serial Port 2 [2F8/IRQ3] Menu Level ►
Serial Port 2 Mode Select [Normal]
x IrDA Duplex Mode Half
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
Enabled