Foxconn 720A - Manual (Page 42)

3
35
SATA Pri-Slave RAID is the SATA port 2.
SATA Sec-Master RAID is the SATA port 3.
SATA Sec-Slave RAID is the SATA port 4.
SATA Thr-Master RAID is the SATA port 5.
SATA Thr-Slave RAID is the External SATA port located on the back panel.
OnBoard Devices
► OnBoard Audio Controller
This item is used to select the operation of your audio controller. You can select [Internal
Codec] to enable and select HDMI audio output. Select [External Codec] to enable Realtek
audio output. Select [INT Codec + EXT Codec] to enable both HDMI and Realtek audio
outputs. Select [Disabled] will turn off audio function.
► OnBoard LAN Controller
This item is used to enable or disable the onboard LAN controller.
► OnBoard LAN Boot ROM
This item is used to enable or disable the onboard LAN boot optional ROM. A LAN boot ROM
lets you set up a diskless workstation on the network. By installing a boot ROM in the network
board, you can enable a client PC system on the network to be booted remotely.
Phoenix - AwardBIOS CMOS Setup Utility
OnBoard Devices
OnBoard Audio Controller [ ] Item Help
OnBoard LAN Controller [Auto]
OnBoard LAN Boot ROM [Disabled] Menu Level ►
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F7: Optimized Defaults
INT Codec + Ext Codec
The Installation procedures for AHCI and RAID drivers are the same, they are :
■ Creating a bootable drive (or RAID array).
■ Creating a non-bootable drive (or RAID array).
In Chapter 5, only RAID is introduced. AHCI installation is almost the same, the only
difference is BIOS SATA Operation Mode is set to [AHCI] instead of [RAID].
CA
UT
IO
N
!