Foxconn Cinema Deluxe - Manual (Page 42)

3
35
Hardware Monitor
► Case Intrustion Alert
This item is used to enable or disable a warning message once the case intrusion alert has
been triggered.
► Hardware Monitor
This item is used to enable or disable Hardware Health Monitoring Device.
► CPU/System/NB Temperature
The CPU/System/NB temperature are automatically detected and displayed by the system.
► CPU Fan/System Fan Speed
The CPU fan/System fan speed are automatically detected and displayed by the system.
► CPU VCore/DRAM Voltage/+ 3.3V/+12.0V/NT/SB Voltage/VBAT
The current voltages are automatically detected and displayed by the system.
► Smart Power LED
Smart Power LED is a feature built on your motherboard to indicate different states during
Power On Self Test (POST). The LED is located at the front panel, and it displays POST state
by different long-short blinking intervals. You can always leave this state enabled.
► CPU Smart Fan Function / System Smart Fan Function
[Full On Mode]; [Automatic Mode].
This option is used to enable or disable smart fan function.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Hardware Monitor
Case Intrustion Alert Help Item
Hardware Monitor [Enabled]
CPU Temperature :45 o C/113 o F Enables a warning
System Temperature :40 o C/104 o F message once the case
North Bridge Temperature :45 o C/113 o F intrusion alert has
CPU Fan Speed :2136 RPM been triggered
System Fan Speed :N/A
CPU VCore Voltage :1.200V
DRAM Voltage :1.920V
+3.30V :3.360V
+12.0V :11.840V
HT/SB Voltage :1.200V
VBAT :3.104V
Smart Power LED [Disabled]
CPU Smart Fan Control [Automatic mode]
Fan off Temperature ( o C) [000]
Fan on Temperature ( o C) [035]
Fan on Startup speed (Z) [064]
Fan slope (Z) [2]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F2/F3:Change Colors F9:Optimized Defaults
[Disabled]
System Status Power LED Status Stop Blinking Condition
Normal Always On Always On
No Memory Continue blinking On (1sec.), Off (1sec.) Reboot & Memory OK
No Display Continue blinking On (2sec.), Off (2sec.) Reboot & Display OK
Post Error Message Continue blinking On (1/2sec.), Off (1/2sec.) Enter Setup or Skip
No CPU Fan Continue blinking On (1/2sec.), Off (1/2sec.) Reboot & Fan OK