Foxconn Cinema Deluxe - Manual (Page 37)

3
30
Integrated Peripherals
► SATA Configuration / USB Configuration
Press to go to relative submenu.
► LAN Controller
This item is used to enable or disable the LAN controller.
► LAN Boot ROM
This item is used to enable or disable the LAN boot optional ROM. A LAN boot ROM
lets you set up a diskless workstation on the network. By installing a boot ROM in the network
board, you can enable a client PC system on the network to be booted remotely.
► 1394 FireWire
This item is used to enable or disable the onboard 1394 controller.
► USB Controller
This item is used to enable or disable the USB controller.
► Azalia HD Audio Controller
This item is used to enable or disable the Azalia HD Audio Controller.
► Serial Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Port Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► IR Port Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
CMOS Setup Utility - Copyright (C) 1985-2009, American Megatrends, Inc.
Integrated Peripherals
► SATA Configuration [Press Enter] Help Item
► USB Configuration [Press Enter]
LAN Controller [Enabled] Configure the SATA
LAN Boot ROM [Disabled] device(s).
1394 FireWire [Enabled]
USB Controller [Enabled]
Azalia HD Audio Controller [Enabled]
Serial Port Address [3F8/IRQ4]
Ir Port Address [2F8/IRQ3]
Ir Port Mode [IrDA]
Ir Port Duplex Mode [Half Duplex]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F2/F3:Change Colors F9:Optimized Defaults
[Press Enter]