Foxconn 6100K8MA-RS User Manual
Page 25
18
Chapter 2 Installation Instructions
Chassis Intruder Connector: INTR
The connector connects to the chassis security
switch on the case. The system can detect the
chassis intrusion through the status of this
connector. If the connector has been closed
once, the system will send a message. To uti-
lize this function, set “ICase Open Warning” to
“Enabled” in the “Power Management Setup”
section of the CMOS Setup. Save and exit, then
boot the operating system once to make sure
this function takes effect.
INTR
1
2
INTRUDERJ
GND
Front Audio Connector: F_AUDIO
The audio port includes two parts – the Front
Audio and Rear Audio. Their priority is se-
quenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front
panel of the chassis (using the Front Audio),
then the Line Out (Rear Audio) on the rear panel
will not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be short,
and then the signal will be sent to the rear au-
dio port.
F_AUDIO
MIC_GND
MIC_IN
+5VA
MIC_PWR
AUD_RET_R
AUD_OUT_R
EMPTY
AUD_OUT_L
AUD_RET_L
1 2
9 10
NC
TV OUT Connector: TV_OUT (optional)
This connector is for TV out function. Using this
function, you can use a TV or projector as display
device. The following steps are provided refer-
ence only.
1
S_VIDIO_C
S_VIDIO_Y
TV _OUT
GND
Step 1. Install TV out cable to a slot opening at the back of the system chassis (As
figure 1).
Note:
The triangle direction on the 3-pin connector should be aligned
to 1st pin of the TV out connector on the motherboard.
A
B
Figure 1
PDF 文件使用 "pdfFactory" 试用版本创建