Foxconn 6100K8MA-RS User Manual
Page 22
15
Chapter 2 Installation Instructions
This motherboard includes connectors for FDD devices, IDE HDD devices,
SATA devices, USB devices, 1394 devices, IR module, CPU fan, system fan, and
others.
FLOPPY
This motherboard includes a standard FLOPPY interface, supporting 360 K, 720 K,
1.2 M, 1.44 M, and 2.88 M FDDs.
IDE Connectors: PIDE & SIDE
These connectors support the Ultra DMA133/100/66 IDE hard disk ribbon cable.
Connect the cable’s blue connector to the primary (recommended) or second-
ary IDE connector, then connect the gray connector to the slave device (hard
disk drive) and the black connector to the master device. If you install two hard
disks, you must configure the second drive as a slave device by setting its
jumper accordingly. Refer to the hard disk documentation for the jumper settings.
Other Connectors
Attention:
Ribbon cables are directional, therefore, make sure to always con-
nect with the cable on the same side as pin 1 of the PIDE/SIDE or
FDD connector on the motherboard.
Front Panel Connector: FP1
This motherboard includes one connector for con-
necting the front panel switch and LED indicator.
NC
HDD_LED
RESET
PLED
PWRBTN#
+
-
9 10
1 2
FP
FP1
!
+
-
Empty
Hard Disk LED Connector (HDD_LED)
Attach the connector to the HDD_LED on the front panel of the case; the LED will
flash while the HDD is in operation.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
PDF 文件使用 "pdfFactory" 试用版本创建