Fluke Biomedical ESA612 - Manual (Page 29)

Electrical Safety Analyzer
Setting Up the Analyzer
15
5. Press the softkey labeled Done to exit the switching
polarity delay setup function.
Setting the Display Contrast
There are two methods for setting the display contrast.
From the Select a Test…. menu or through the setup
menu.
Whenever the Analyzer displays its start-up menu (Select
a test…), pressing  or  will increase or decrease the
display’s contrast respectively. Press the softkey labeled
Done
to exit contrast setup.
Another way to adjust the contrast is through the
Analyzer’s setup menu.
1. From the setup menu, press the softkey labeled
More twice to set F1 to the display contrast function.
2. Press the softkey labeled Display Contrast.
3. Press
 or  to increase or decrease the display’s
contrast respectively.
4. Press the softkey labeled Done to exit contrast
setup.
Setting up the Beeper
To enable or disable the beeper:
1. From the setup menu, press the softkey labeled
More twice to set F2 to the beeper on/off function.
2. Press the softkey labeled Beeper to switch the
beeper on and off.
3. Press the softkey labeled Done to go back to the
setup menu.
Viewing Instrument Information
To view information about the Analyzer:
1. From the setup menu, press the softkey labeled
More twice to set F3 to the instrument information
function.
2. Press the softkey labeled Instrument Information.
3. After viewing the displayed information, press the
softkey labeled Done to exit the information screen.