Flowserve URB 1 - Manual (Page 58)

58
Basic Settings
– continued –
Adjusting LIN (linear) temperature compensation
Press button once briefly to activate
the line editing mode.
The split-screen main window shows
which GESTRA bus devices can be
indicated:
■ High-level limiter NRS 1-41
■ Low-level limiter NRS 1-40
■ Level switch NRS 2-40
■ Level controller NRR 2-40
■ Conductivity controller LRR 1-40
Press button four times briefly to enter the
window where the following parameters can
be set:
■ Linear temperature compensation [% / °C]
■ Recording a temperature curve
■ Cell constant C of the conductivity
electrode
The factory set default setting is “TK:LIN”.
4 times briefly
once briefly