Flowserve URB 1 - Manual (Page 16)

16
Basic Settings
– continued –
Changing factory set node ID of the URB 1 / Adjusting & changing node ID
The factory set node ID of the URB 1 is
“060”. Node IDs below this value are
reserved for other GESTRA bus
components.
If additional operating terminals type URB 1
are used in a CAN bus system, you have to
set their node IDs to values above “060”.
Note that the newly established node IDs
must not be identical with node IDs of other
bus components.
Press and hold button for a few
seconds to enter the address
parameterisation mode.
Press button briefly to activate the
line selection mode.
a few seconds
briefly