Flowserve PSS III Durametallic - Manual (Page 14)

14
Figure 33
13.5 Repeat this procedure for the other seal drive half.
13.6 Lubricate the exposed surfaces of each sleeve gasket including
the ends and the split joint gaskets with silicone grease.
13.7 Wipe the rotating faces clean with alcohol.
Caution: Consult material safety data sheets for proper handling of
alcohol.
14 Stationary Face Installation
14.1 Lubricate the exposed surfaces of the seat gasket including the
ends, the stationary face shoulder, and the stationary face back
surface that contacts the spring holder with silicon grease.
13.1 Set the seal drive face up on the
bench. Lubricate both sides of
the vibration damper with silicone
grease. Place the vibration
damper on the seal drive rotating
face support surface using the
drive pin as a locator.
See Figure 32.
13.2 Lubricate the exposed surfaces
of the rotating face gasket
including the ends and the
rotating face shoulder with
silicone grease.
13.3 Position the rotating face back
surface downward over the
vibration damper aligning the
drive pin with the pin slot.
13.4 Push the rotating face radially
into the seal drive and then down
as the drive pin slips into the drive
slot. The rotating face should sit
flat on the vibration damper.
See Figure 33.
13 Rotating Face Installation
Figure 32