Flowserve PSS III Durametallic - Manual (Page 13)

13
11 Spring Holder Installation
11.1 Place the coil springs in the
spring holes. See Figure 28.
11.2 Set the gland half face down on
the table and insert half of the
spring holder into the gland.
See Figure 29.
11.3 Lubricate one end of the
lock pins and set them into the
lock pin holes in the gland and
align them with the holes in the
spring holder.
11.4 Keep the spring holder snug in
the gland bore and press the
lock pins into the spring holder
until the pins extend 1.5 mm
(0.06 inch) out of the gland.
See Figure 30.
11.5 Repeat this procedure for the
other gland half.
Figure 28
Figure 29
12 Centering Device Installation
Figure 31
12.1 Place one gland half on the
table face down.
12.2 Position the centering devices at
the gland locating holes and
press their tabs into the locating
holes. The locating holes are
positioned 45 degrees from the
split joints and are even with the
bolt slots. See Figure 31.
12.3 Repeat this procedure for the
other gland half.
Figure 30
1.5mm (0.06 inch)