Flowserve MNV User Manual
Page 10

MNV & MNZ USER INSTRUCTIONS ENGLISH 71569188 11/04
Page 10 of 47
®
1.9 Specific machine performance
For performance parameters see section 1.5,
Duty
conditions
. When the contract requirement specifies
these to be incorporated into User Instructions these
are included here. In cases where performance data
has been supplied separately to the purchaser these
should be obtained and retained with these User
Instructions, if required.
2 TRANSPORT AND STORAGE
2.1 Consignment receipt and unpacking
Immediately after receipt of the equipment it must be
checked against the delivery and shipping
documents for its completeness and that there has
been no damage in transportation.
Any shortage and or damage must be reported
immediately to Flowserve Pump Division and must
be received in writing within one month of receipt of
the equipment. Claims made later than this specified
time period will not be accepted.
Check any crate, boxes, and wrappings for any
accessories or spare parts that may be packed
separately with the equipment or attached to
sidewalls of the box or equipment.
Each product has a unique serial number. Check
that this number corresponds with that advised and
always quote this number in correspondence as well
as when ordering spare parts or further accessories.
2.2 Handling
Boxes, crates, pallets or cartons may be unloaded
using forklift vehicles or slings dependent on their
size and construction.
2.3 Lifting
To avoid distortion, the pump unit
should be lifted as shown in sections 2.3.1.
It is strongly recommended to lift the pump using
appropriate equipments and proven procedures. It is
strongly recommended to employ experts for the task
to avoid injury or loss of life.
A crane must be used for all pump sets in
excess of 25 kg (55 lb). Fully trained personnel must
carry out lifting, in accordance with local regulations.
2.3.1 Lifting of pump together with the suction
elbow/nozzle
(only MNZ configuration is shown in this illustration)
Use stuffing box head and /or lifting eyes (if provided)
on the casing for lifting. Make sure to balance the
weight such that there is no tilting to any one side.