Fire Magic Aurora Single Sideburner Slide-in 3279 Series - Manual (Page 13)

13 L-C2-189 REV 7 - 1407151420
Fig. 13-1 Remove burner
d. Remove the burner cap and carefully lift the burner
up and out, clearing the ceramic electrode (see Fig.
13-1), and pulling the burner tube away from the
orifi ce, located on the end of the orifi ce holder on
the left side of the unit (see Fig. 13-2).
Note: You do not have to lift the burner completely out of
the unit to access the orifi ce.
e. Using a 3/8" socket, remove orifi ce from the orifi ce
holder (see Fig. 13-2) and check the number
stamped on the orifi ce face.
f. If an orifi ce change is necessary, replace the orifi ce
with the correct sized one.
g. Replace the sideburner tube over the orifi ce, aligning
the burner over the electrode, taking care not to
detach it from the wire.
h. Replace the burner retaining clip (underneath
burner), burner cap, cooking grid, and cover.
Important: If conver ting the gas type, see the
CHECKING AND CONVERTING THE
REGULATOR section before replacing
the control panel.
i. Replace the control panel, being sure to reconnect
the battery holder assembly wires. Replace the
control knob.
CONVERTING THE GAS TYPE (Cont.)
Fig. 13-2 Orifi ce location
Orifi ce is located at
the end of the valve