Converting the gas type installation (cont.) – Fire Magic Aurora Single Sideburner Slide-in 3279 Series User Manual
Page 12
12
L-C2-189
REV 7 - 1407151420
Fire Magic units are equipped with orifi ces for natural
gas, unless otherwise indicated. For use with propane
gas, smaller orifi ces must be installed to avoid hazardous
overheating. Please refer to Table 1 for the correct orifi ce
size. Check the orifi ce size by following the instructions
below. The drill size is stamped on the orifi ce. If the
number is not visible you may have to remove the orifi ce
(as detailed below) to read the number stamped on the
side of the orifi ce.
IF YOU ARE NOT SURE YOU HAVE THE CORRECT
SIDEBURNER ORIFICE SIZE (OR WISH TO CHANGE
THE ORIFICE), FOLLOW THE STEPS BELOW.
CAUTION: If the burner has been in use, wait until
the burner and its components are
cool to the touch.
a. Remove sideburner cover and lift off cooking grid.
b. Remove the control knob and screws fi rst, then
carefully lift away the control panel.
Important:
Prior to fully removing the control
panel, you must disconnect the
battery holder assembly wires that
are located behind the control panel.
c. Reach up under the burner support and remove the
burner retaining clip (see Fig. 12-3), located at the
rear of the burner pipe.
CONVERTING THE GAS TYPE
INSTALLATION (Cont.)
d. Close the dedicated gas-supply shut-off valve, then slide
the unit into place. Do not to pinch, kink, or damage the
gas connector line.
Note: Each side of the unit has a tab just behind
the control panel. These tabs prevent the
control panel from moving inward. If the
tabs interfere with the unit sliding in (see
Fig. 12-1), use pliers to bend them inward
so that they clear the enclosure sides.
Leave the tabs slightly out to ensure they
still keep the control panel from moving
inward (see Fig. 12-2).
POSITIONING THE BURNER CAP
Place the burner cap so it is centered over the burner.
Ensure that it rests securely in place.
Fig. 12-3 Remove burner clip
Fig. 12-1 Tab may interfere when
sliding in unit
Fig. 12-2 Tab slightly bent in for
clearance
Procedure continued on next page