Fire Magic Diamond Single Sideburner 32794-1 Series - Manual (Page 5)

5
▲
The increased dimensions for combustible enclosures allow for a required air gap along
the sides and rear of the unit. See the COMBUSTIBLE ENCLOSURE CUT-OUT section
on the next page for details.
† Includes any substrate at front wall of enclosure (in the area the rear of the control panel
is to sit fl ush against). See SUBSTRATE section on next page.
‡ Only applicable for enclosures that have countertops with an overhang (see illustration
and section below).
COUNTERTOP OVERHANG
The control panel is designed to sit fl ush against the enclosure front wall. If the enclosure countertop extends beyond the front wall,
creating a countertop overhang, it must be cut fl ush with the front wall for the width of the control panel or a gap will be created exposing
the forward portions of the left and right side fi re walls of the unit. See illustrations above.
Important: FOR YOUR SAFETY, you must provide openings in the island enclosure for drainage, replacement air, and cross-
ventilation of any storage area exposed to possible leakage from gas connections, the unit, or propane tanks. See the
ENCLOSURE REQUIREMENTS section for details.
MODEL SPECIFICATIONS
TOP VIEW
(Countertop)
Lower support
Countertop
overhang
Control
panel
ENCLOSURE
CUT-OUT
DIMENSIONS
Fig. 5-1
FRONT VIEW
B
C
D
See next page
for substrate
considerations
Countertop
overhang
X
TOP VIEW
SIDE VIEW
Countertop
overhang
(Control
panel)
(Countertop)
Y
1 / 4 "
Clearance
(Overhang)
X= 7 / 8 "
Y= Total
Countertop
Overhang
A
Control
panel
Check
clearance for
control panel
removal
REV 2 - 1502100745 L-C2-378
MODEL SPECIFICATIONS TABLE
Table 1
Main burner
N/P orifi ce drill size
#51 / #58
Input electrical requirements 120VAC / 15 AMP minimum / 60 Hz / GFCI outlet
Non-combustible
enclosures
Combustible
enclosures
A Countertop to unit bottom cut-out 12" 12"
B Side to side cut-out 11- 1 /
2
" 12"
▲
C Front to back cut-out† 14" 14- 1 /
2
"
▲
D Control panel width cut-out‡ 12- 5 /
8
" 12- 5 /
8
"