Fire Magic Diamond Single Sideburner 32794-1 Series - Manual (Page 17)

17
Air shutters are preset at the factory based on the
gas the sideburner is built to burn. However, altitude
or other local conditions may require air shutter
adjustment for proper combustion.
The fl ames from a properly adjusted sideburner will
touch the burner ports and appear mostly blue.
If they are orange, “lazy,” or lift off the burner ports,
then adjust the sideburner air shutter using the
following steps.
The air shutter is located at the end of the burner
assembly, behind the control panel. It can safely and
easily be adjusted while the unit is lit.
CAUTION: Do not touch the sideburner surrounding
top area, as it will be hot while adjusting
the air shutter.
1. Remove the control panel. See the CONTROL
PANEL REMOVAL section for details.
2. Replace the control knob back on to the valve stem .
3. Light the sideburner following the LIGHTING
INSTRUCTIONS section.
4. Loosen the burner air shutter adjustment screw,
then use the tip of a screwdriver to open or close
the air shutter until the fl ames appear blue and
touch the burner ports.
5. Retighten the adjustment screw.
6. Once all adjustments are complete; be sure the
unit is off and remove the knob, then replace the
control panel, bezel, and knob.
Fig. 17-1 Flame pattern
Fig. 17-2 Adjust air shutter
Close
Open
AIR SHUTTER ADJUSTMENT
REV 2 - 1502100745 L-C2-378