Fire Magic Diamond Single Sideburner 32794-1 Series - Manual (Page 24)

24
To remove the control panel:
1. Turn the control knob to the OFF position and turn off the gas supply to the unit.
2. Turn off the light switch and disconnect the power supply from the power source.
3. Pull the control knob from the stem and set aside .
4. Slowly lift away the lighted bezel to clear the valve stem, and carefully disconnect the wire found on
the back of the bezel (use your fi ngernail). See Fig. 24-1.
5. Using a Phillips screwdriver, unscrew and remove the control panel fastener screws and washers
(located on the left and right front face of the control panel). Retain the screws for later re-installation .
6. Carefully open the control panel by lifting and pulling the control panel from the frame .
Important: When opening, take caution to not damage any wiring.
7. If wire disconnections are required, reference the wire diagram in the MODEL SPECIFICATIONS
section in this instruction manual or the wire diagram label affi xed to the inside of the control panel.
Note: Secure any disconnected wires (coming from the inside of the unit) to prevent them from falling in.
Note: Whenever reconnecting any wires, apply a small amount of dielectric grease to the male connector,
then make the connection.
Important: During reinstallation; prior to opening the gas shutoff valve, be sure the control knob is in
the OFF position.
CONTROL PANEL REMOVAL