ESI Audioterminal 010 - Manual (Page 9)

10
3. Audioterminal 010 Software Installation
After completing the installation of hardware for the Audioterminal 010, you need to install its driver’s
software to use it under Windows. The software installation is not too hard, even for computer beginners.
Just follow the steps below and you will complete it without any problems.
*** Caution – The Main board, which adapts new chipset, have to be install patch provided by
Main Board Company or Chipset manufacturer.
First, You have to check the company, model number, chipset of your main board and then download
patch from below links.
http://support.intel.com/support/chipsets/
http://www.amd.com/support/software.html
http://www.viatech.com/jsp/en/dr/driver.jsp
The installation steps under Windows 98SE, Windows Me, Windows 2000 and XP are a
little bit different from each other.
Below installation is the case of Windows 2000.
However, Driver installation procedure is similar to other Windows version.
1. After the hardware installation, turn on your computer. Windows will automatically recognize the AT
010 showing the message that it detected a ‘PCI Multimedia Audio Device.’