ESI Audioterminal 010 User Manual

Page 21

1. Output Level Fader/Level Meter

These faders are the output volume control faders that controls 10 outputs of the Audioterminal

010.

10 outputs consist of 5 Stereo channels and you can adjust 8 Multi channels and SPDIF 2 channel.

Each faders act the same so you need to learn only one.

a. MUTE – Channel Mute button

Press these buttons to mutes the selected channel. When you press middle of this button, 2

channels become muted. If you press left or right of this button, selected channel becomes muted.

* This function only works when the Master Fader selected as ‘MAIN’.

b. SOLO – Channel SOLO Button

Press these buttons to output only the sound of a selected channel. When you press middle of this

button, 2 channels become muted. If you press left or right of this button, selected channels

becomes SOLO mode.

* This function only works when the Master Mixer Fader selected as ‘MAIN’.

c. Level Fader

Level Faders would change the level of the output volume. Each fader consists of stereo pairs.

However, you can control outputs individually or stereo pairs. You need to move the mouse

pointer over the specific port fader to adjust it individually or move the mouse pointer over the

middle of the two ports to adjust it as a stereo channel. If the port fader is selected, it will turn

into a brighter color.

You can move the fader in three different ways. Basically, the volume level can be adjusted by

±1.5dB.

Drag the fader as you press the left mouse button.

Select the fader with the mouse cursor and adjust with the mouse wheel. You can

select the steps from the pull down menu, ‘Config’ -> ‘Mouse Wheel’

Select the fader with the mouse cursor and use the up and down arrows of your

keyboard.

* This function only works when the Master Mixer Fader selected as ‘MAIN’.