Entone FusionTV - Manual (Page 6)

User G
U
ide
User G
U
ide
Setup Wizar
d
Setup Wizar
d
4 5
Setup Wizard
Setting up FusionTV is quick and simple. Just follow the on-screen instructions
to get started. This initial setup process may take up to 30 minutes. When you
are ready to begin, press OK to proceed to the next screen.
NOTE: The Setup Wizard process can be repeated in the future if you relocate the device or
change TV sources, such as Antenna or Digital Cable (Clear QAM/CableCARD). From the
Main Menu select “ SETTINGS ”, “ Restart & Reset ” and “ Repeat Setup Wizard ”.
Step 1 of 4: Setting up Date and Time
Choose the correct time zone for your location. This is an important step to
ensure your TV recordings are scheduled properly.
1. Time Zone:
a. Use the ARROW KEYS , then press OK to select your time zone.
2. Daylight Savings Time (DST):
a. Use the ARROW KEYS. Select “ Yes ” if your time zone observes DST.
Select “ No ” if you are located in a time zone that does not observe DST.
b. Press OK to make your selection.
3. Date and Time Mode:
a. Select “ Automatic ” (recommended) for the device to automatically
manage the time. The device will use your broadband connection to
automatically get the most accurate information.
Select “ Manual ” to modify the date and time manually. You will need to
use the ARROW KEYS and the OK button to change each value.
b. Press OK to proceed to the next step.
Step 2 of 4: Selecting your TV Settings
This step will ensure your FusionTV experience will output properly to your
TV. Please select the proper resolution and the aspect ratio that matches your
TV. To make changes to the resolution and aspect ratio, perform the following
steps.
1. TV Resolution:
a. Use the ARROW KEYS to select your TV resolution.
b. Press OK .
2. TV Aspect Ratio:
a. Use the ARROW KEYS to select the desired aspect ratio, then press OK .
If you enter settings outside the range for your display, the screen may
turn blank or become unclear. At this point, do not select “ NEXT ”. Leave
the controls untouched for at least 15 seconds and the setup wizard will
return the display settings to their previous values.
b. Press OK to proceed to the next step.