Entone Hydra II User Manual
Page 42
Hydra User’s Guide
Copyright
2007 Entone, Inc. All rights reserved
.
40
SETTING CHANNEL ID
In “TV OUT”, decoder 1 by default is set to channel 10. In “MATV OUT”, decoder 1, 2 and 3 by default are
set to channel 10, 12 and 23 respectively.
You can change the channel ID used by decoder 1, 2 or 3 by using the User Menu.
Follow procedures in
Section 14.1 Hydra User Menu
to make the changes.
NOTE:
Decoder 1 channel ID in “TV OUT” and “MATV OUT” cannot be set separately. They can only be
set together.
The new channel ID will only take effect after rebooting the Hydra.
Do not set decoders to use the same channel ID.
It is recommended to use channel IDs farther apart for the three decoders to minimize inter-
modulation interference. For example, do not use consecutive channel ID 10, 11 and 12 for
decoder 1, 2 and 3. Use channel ID 10, 23 and 39 instead.