Entone Hydra II User Manual

Page 11

Hydra User’s Guide

Copyright 



FRONT PANEL AND REAR PANEL

Figure 2-1 Hydra Front Panel

Part Name

Description

1. Standby Switch

Power up or put Hydra in standby mode

2. Smart Card Slot

Optional for conditional access authentication

3. Standby/On Indicator

Amber: standby mode and starting;
Green: when started
Red: in remote registration mode

4. IR receiver

Remote control IR receiver.
If the receiver is flashing Red/Green: upgrading software

5. Arrow Keys/OK Button

Usage determined by middleware

6. Reset Pin Hole

Restart Hydra

Figure 2-2 Hydra Rear Panel

Part Name

Description

1. ADSL

The ADSL RJ11 port is used to connect an ADSL line when the
Hydra's internal ADSL router is used.

2. TO LINE

RJ11 plug for connecting to telephone line for caller ID display

3. ETHERNET

1) This RJ45 port can function as the primary WAN connection

when the Hydra's internal ADSL router is not used.

2) When the internal ADSL router is used, this port provides a

data connection for PC's and other in-home networking
equipment.

4. OPTICAL AUDIO/DIGITAL

AUDIO

S/PDIF digital optical audio TOSLINK output for decoder 1
S/PDIF digital coaxial RCA audio output for decoder 1

5. S-VIDEO

S-Video output for decoder 1

6. AUDIO LEFT/RIGHT

Composite audio output for decoder 1

7. VIDEO

Composite video output for decoder 1

8. YPbPr

Component video output for decoder 1

9. MATV OUT

RF Type-F connector for decoder 1, 2 and 3 (factory set to channel
10, 12 and 23)

10. TV OUT

RF Type-F connector for decoder 1 (factory set to channel 10)

11. REMOTE ANTENNA

RF Type-F connector for connecting the RF remote control antenna

12. DC INPUT

12V DC power jack