Entone Hydra II User Manual

Page 29

Hydra User’s Guide

Copyright 



ATTACHING THE RF REMOTE CONTROL ANTENNA

You need to attach the RF Remote Control Antenna to the Hydra’s rear panel “REMOTE ANTENNA” input
in order to use the radio control remotes.

Figure 9-3 Attaching Remote Control Antenna

NOTE: Be sure to set the antenna straight up so that you can use the remote control from as far away as

possible. Don’t let the antenna touch anything.

ATTENTION: If your remote control isn’t working very well from far away, you may be experiencing

interference from objects near your receiver. To improve your remote control’s range, try any
or all of the following:

1. Place the receiver higher than all of the other equipment in your entertainment center.
2. Provide room above the receiver so that the antenna can be installed straight up. If this is not possible,

tilt the RF Antenna at about a 30° angle.

3. Place the RF antenna outside the entertainment center by using a coaxial cable to connect the antenna

to the Hydra.

4. Try moving the Hydra to other locations.