Echo Bear Cat 70554S - Manual (Page 6)

3
S E C T I O N 1
6. Do not allow processed material to build up in
the discharge area; this may prevent proper
discharge and can result in kickback of material
through the feed opening.
7. Do not attempt to operate the chipper with any of
the guards, deflectors, or shrouds removed. Keep
away from moving parts.
8. Keep all guards, deflectors, and shrouds in good
working condition.
9. Always stand clear of the discharge area when
operating this machine.
10. Keep your face and body back from the feed opening.
11. Do not overreach. Keep proper balance and footing
at all times.
12. Do not transport or move machine while the ma-
chine is running.
13. If the machine becomes clogged, shut off engine.
Allow machine to come to a complete stop before
clearing debris.
14. On electric start models, disconnect cables from
battery before doing any inspection or service.
15. Do not tamper with the engine governor settings on
engine models; the governor controls the maximum
safe operating speed and protects the engine and all
moving parts from damage caused by over-speed.
Additional Safety Rules for
Towable Models
1. Always connect hitch safety chains. Make sure
trailer hitch bolts are tight and secure. Do not
attempt to tow the trailer if vehicle is not equipped
with a 2" ball.
2. Maximum towing speed should not exceed 55
M.P.H. Inflate tires to manufacturer's specifications
as stated on the tire sidewall. Check wheel lug bolts
periodically to be sure they are tight and secure.
3. Make sure that the jack stand on trailer is in the UP
position to clear the ground during towing. Place
the jack stand on a level surface and secure it in the
DOWN position before use.
4. Shut off fuel supply to engine when towing.
5. Disconnect spark plug wire when towing.
Maintenance and Storage
(Towable Models)
1. When this equipment is stopped for servicing,
inspection, storage, or to change an accessory, make
sure that the spark plug is disconnected.
2. Store the machine out of the reach of children and
where fuel vapors will not reach an open flame or
spark. For storage periods of three months or more,
drain the fuel and dispose of it in a safe manner.
Always allow the machine to cool before storing.
Additional Safety Rules for PTO
Models
1. Connect 3 pt. hitch pins and snap pins, connect
P.T.O. shaft and have leg stands secured in DOWN
position when in use.
2. To move unit: Shut off P.T.O., lift 3 pt. hitch, and
adjust leg stands if needed.
3. Keep guards and shields in place at all times while
operating. Always disengage the tractor P.T.O and
shut off the engine before removing guards or shields.
4. Keep hands, feet, and clothing away from all P.T.O.
drive parts.
5. Never clean, lubricate, or adjust the chipper/shred-
der when it is running.
6. Clothing worn by operator must be fairly tight.
Never wear loose clothing or clothing with draw
strings when working around P.T.O.
7. Before starting the tractor, always make sure the trans-
mission is in neutral or park and P.T.O is disengaged.
Note: This machine is designed to operate with
P.T.O. ratings from 15 to 30 H.P. Use of P.T.O
ratings above 30 H.P. may cause belt and machine
damage in overload conditions.
Maintenance and Storage (PTO
Models)
1. When this equipment is stopped for servicing,
inspection, storage, or to change an accessory, make
sure to disengage the P.T.O. and shut off the tractor
engine.
2. Store the machine out of the reach of children. For
storage periods of three months or more, clean the
machine thoroughly and store in a dry area.