Echo Bear Cat SC5614 - Manual (Page 16)

5 INCH CHIPPER/SHREDDER 12
Section
5
sERvIcE & maINTENaNcE
5.1 sERvIcE & maINTENaNcE scHEduLE
sERvIcE aNd maINTENaNcE scHEduLE
FREQuENcY
compoNENT maINTENaNcE REQuIREd
REFER To
ENGINE
opERaToR’s
maNuaL
bEFoRE
EacH
usE
EvERY
8
HouRs
EvERY
25
HouRs
EvERY
50
HouRs
EvERY
YEaR
AIR ClEANER CHECK AND ClEAN (1)
AIR INTAKE ClEAN (1)
ENgINE OIl CHANgE (1)
FuEl FIlTER REPlACE
SPARK Plug CHECK CONDITION AND gAP
ENgINE OIl CHECK/FIll
FuEl TANK CHECK/FIll
All INTERNAl AND EXTER-
NAl NuTS AND BOlTS
CHECK TIgHTNESS
TIRE PRESSuRE CHECK
BATTERy CONNECTIONS CHECK
CHIPPER ANVIl CHECK ClEARANCE (2)
CHIPPER BlADES
CHECK SHARPNESS AND RE-TORQuE
TO 25 FT-lBS (2)
SHREDDER KNIVES CHECK CONDITION
ENTIRE MACHINE ClEAN
PTO CROSS JOuRNAlS luBE
PTO INNER TuBES luBE
PTO SHIElD RETAININg
BEARINg
luBE
DRIVE BElT CHECK
BElT TENSION CHECK
BElT/PullEy AlIgNMENT CHECK
gREASE ZERKS luBE
WHEEl BEARINgS CHECK AND REPACK
COOlINg SHROuDS ClEAN
STARTER DRIVE SERVICE
(1) PERFORM MORE FREQuENTly uNDER EXTREMEly DuSTy CONDITIONS.
(2) PERFORM MORE FREQuENTly WHEN CHIPPINg DRy OR DIRTy WOOD.
as the Limited Warranty states, failure by the owner to perform normal maintenance will void the machine’s warranty. The aggressive,
high-speed nature of chipping REQuIREs THE oWNER To pERFoRm THE abovE LIsTEd NoRmaL maINTENaNcE. special consider-
ation to maintain and re-torque the cHIppER aNvIL, cHIppER bLadEs, aNd aLL INTERNaL aNd EXTERNaL NuTs aNd boLTs is the
sole responsibility of the owner. Failure by the owner to do so shall be cause for denial of warranty.
The items listed in this service and maintenance schedule are to be checked, and if necessary, corrective action taken.
This schedule is designed for units operating under normal conditions. If the unit is operating in adverse or severe
conditions, it may be necessary for the items to be checked and serviced more frequently.
sEE ENGINE oWNER’s maNuaL FoR FuRTHER ENGINE maINTENaNcE aNd TRoubLEsHooTING
INFoRmaTIoN.