Echo Bear Cat SC5614 - Manual (Page 13)

5 INCH CHIPPER/SHREDDER 9
ENGLI
sH
FEATURES & CONTROLS
ENGINE THRoTTLE
Changes engine speed. push lever to
1/2 throttle for starting. Push lever to
slow for idle and warm-up. Push throttle
lever to slow throttle to shut engine off.
Refer to engine manual for further engine
operating instructions. When chipping
or shredding, the engine should be at
full throttle.
ENGINE cHoKE
use when starting a cold engine.
Move lever to the choke position when
starting. Move lever to the run position
when engine is running. Refer to engine
manual for further engine operating
instructions.
KEY sWITcH
used to start the engine. To start the
engine, activate the starter switch and
release the switch as soon as the engine
is running. Do not crank starter for more
than 10 seconds or damage may result.
6. jacK sTaNd
Always have the jack stand retracted from the
ground when moving the unit. When in use, be
sure the jack stand is down and locked in position
with the snap pin.
2. bELT ENGaGEmENT pEdaL
used to engage the rotor drive belt.
3.2 ENGINE modEL
7. sHREddER cHuTE
Materials to be shredded are fed through the shredder
chute to the shredder knives.
4. cHIppER cHuTE
Materials to be chipped are fed through the
chipper chute to the chipper blades.
4
7
1
6
3
2
5
1. baTTERY boX
Stores the battery
5. dIscHaRGE dooR
Shredded and chipped materials exit through
the discharge door to the ground.
3. bLadE accEss covER
Remove this cover to access the chipper blades.