Echo Bear Cat SC5540B - Manual (Page 13)

5 INCH CHIPPER/SHREDDER 9
ENGLISH
Section
SERVICE & MAINTENANCE
5
5.1 SERVICE & MAINTENANCE SCHEDULE
The items listed in this service and maintenance schedule are to be checked, and if necessary, corrective action taken.
This schedule is designed for units operating under normal conditions. If the unit is operating in adverse or severe
conditions, it may be necessary for the items to be checked and serviced more frequently.
SEE ENGINE OWNER’S MANUAL FOR FURTHER ENGINE MAINTENANCE AND TROUBLESHOOTING
INFORMATION.
SERVICE AND MAINTENANCE SCHEDULE
FREQUENCY
COMPONENT MAINTENANCE REQUIRED
BEFORE
EACH USE
EVERY 8
HOURS
EVERY 25
HOURS
EVERY 50
HOURS
ALL INTERNAL AND
EXTERNAL NUTS AND
BOLTS
CHECK TIGHTNESS
CHIPPER ANVIL
CHECK CLEARANCE AND RE-TORQUE TO 75 FT-LBS.
(1)
CHIPPER BLADES CHECK SHARPNESS AND RE-TORQUE TO 25 FT-LBS
SHREDDER KNIVES CHECK CONDITION
ENTIRE MACHINE CLEAN
PTO CROSS JOURNALS LUBE
PTO INNER TUBES LUBE
PTO SHIELD RETAINING
BEARING
LUBE
DRIVE BELT CHECK
BELT TENSION CHECK
BELT/PULLEY
ALIGNMENT
CHECK
GREASE ZERKS LUBE
(1) PERFORM MORE FREQUENTLY WHEN CHIPPING DRY OR DIRTY WOOD.
As the Limited Warranty states, failure by the Owner to perform normal maintenance will void the machine’s warranty. The aggressive, high-
speed nature of chipping REQUIRES THE OWNER TO PERFORM THE ABOVE LISTED NORMAL MAINTENANCE. Special consideration
to maintain and re-torque the CHIPPER ANVIL, CHIPPER BLADES, AND ALL INTERNAL AND EXTERNAL NUTS AND BOLTS is the sole
responsibility of the Owner. Failure by the Owner to do so shall be cause for denial of warranty.