Drake SCT4860 8PSK Sat-1024QAM Cable Transcoder - Manual (Page 14)

14
using the SCts with the LBS2250 L Band Splitter: the LBS2250 unit should be mounted above the Rmt150
with no extra space between the units. one or two LNB, L band inputs in the range of 950 to 2250 mHz may be
connected to the inputs of the LBS. on the front panel side of the rack, the LNB inputs of each SCt should be
connected with a short coaxial jumper cable to the output of the LBS that is directly above it. then the power
supply cable of any one of the transcoders should be 'looped through' the LBS2250.
When a LBS2250 has been connected as described in the previous paragraph, a new menu will appear in the
SCt menu chain, between the moDe and CHANNeL menus (see chart). this is where the user may select the
setting of the LNB input switch for that transcoder - either LNB input A or LNB input B may be selected.
An eight character name such as 'DiSH 110' can be programmed for the A setting and the B setting so that
the setting is more meaning if monitored remotely. this name may be programmed only via the RS232 remote
program using version 2.7 or above CDRom.
Additional Features (continued)