Drake EH244 SERIES - Manual (Page 15)

EH244 ENCODER HOST SERIES
CONFIGURATION (continued)
The bottom section configures the per-stream output settings:
Image: EH244 Web-Server Control Panel, IP OUTPUT Tab
In MPTS mode, there are 4 streams possible (corresponding to the 4 transport multiplexes assigned
from the Output tab). In SPTS mode, there are 12 streams available, corresponding to the 12
possible encoder channels in the EH244 Series Encoder Host chassis.
For MPTS mode:
1. Configure the channel’s destination in Configuration Settings.
2. ENABLE or DISABLE the channel.
3. Click the lower APPLY button.
The destination IP address must be a multicast address (224.000.000.000 - 239.255.255.255),
and the UDP ports must be within the range of 1 - 65535 each. The output stream format is RTP-
encapsulated within UDP.
For SPTS mode, configuration is the same as MPTS mode, but you must also choose which transport
multiplex source (configured in the Output tab) the encoder source is assigned to.
(continued on Page 16)
15