DR Power Redi-Plow Plus (Sept. 2013 - Present) User Manual

Page 13

4. To start a pass, Drive forward slowly allowing for tire traction and for the

blade to accumulate snow.

5. As you come to the end of the pass, reduce speed and start applying brakes

as needed.

6. Back up to disengage the blade and continue backing up until you are

realigned for next push.

7. Repeat this procedure until job is finished. Deep and/or compacted snow

may require several passes.

The blade can be angled by removing swivel pin, turning blade to desired angle
position and reinserting pin (Figure 30).

Angled Interceptor Note: There are two holes in the interceptor shaft. When

inserting angle interceptor into front mount receiver,
select the hole which allows blade to swing as far as
possible without contacting vehicle.

TO STORE BLADE FOR TRANSPORTING:

Reverse procedure from “Lowering the Blade for Pushing Snow” and re-insert
keyhole pins (Figure 28).



Do not exceed 65 MPH when transporting plow.

Note: When transporting blade, secure it to hanger brackets with pins or locks.

Angle
Interceptor

Figure 30

Push Frame

Swivel Pin

Straight Position

Angled to Right

Angled to Left