DR Power 6.0 HP Pro Power Wagon (June 2002 - January 2007) - Manual (Page 23)

POWERWAGON
™
Safety & Operating Instructions 23
To Remove or Replace the Stake Body or the Molded Body
Tool Needed:
• (2) 1/2" open-end or box wrenches
!
WARNING: Always disconnect the spark plug wire before servicing your machine.
1. Position the machine on a level
surface. Set the parking brake.
2. Tip the bed forward.
3. Remove the four sets of nuts and bolts,
as shown (Figure 29).
4. Carefully lift and remove the body.
5. Follow these instructions in reverse to
attach other body.
To Remove the Cinder
Blocks
Tool Needed:
• 7/16" wrench
!
WARNING: Always disconnect the
spark plug wire before servicing your
machine.
1. Position the machine on a level
surface. Set the parking brake.
2. Tip the bed forward.
3. Loosen the bolts and lock nuts with the
wrench on the front and the rear of the
weight rack block strap (Figure 30).
Pull the strap up and off and store in a
safe place.
4. Remove the three cinder blocks.
5. The cinder blocks must be replaced
and secured with the strap for stability
when dumping and for traction on
slopes with light loads.
Figure 25
Figure 26